The thickness of the substance is 4 mm.

If you want, you can boost the length of the structure to 6 metres or more. To do this, it is sufficient to attach a two-meter extension. When selecting a drawing, pay attention to the space between the arches. This figure needs to be 65 cm, and which is the most appropriate length for the specified depth of the material. The width of the doors according to the maker’s drawing is 90 cm.

Before assembling a polycarbonate greenhouse, then it’s important to select a place because of its location. If this is done properly, you can provide yourself with a harvest of fresh veggies for the entire year.

The place for your future greenhouse is marked instantly in the preparation of the garden plot. So as to melt the snow in the positioning of their greenhouse as early as possible, the ideal point on the site is going to be a small elevation. Additionally, in such a place won’t need to worry about large humidity as soil and atmosphere in the construction.

Build a polycarbonate greenhouse on an elevated site – means to take care of the optimal temperature inside.

If it isn’t feasible to place a greenhouse on an elevated position, you’ll have to pour a layer of fine shattered rock around 20 cm and the identical layer of fertile soil to create seedbeds.

Before assembling a greenhouse on your garden plot, you should also think about where and how this structure is going to be installed. First, you have to pick a location for this. The greenhouse ought to be located at a well-lit area at least a couple meters away from houses, barns and other structures.

The best way to install a greenhouse in Line with the Faces of the Planet

Make sure you measure the dirt surface – it’s best to remove the surface. This will also get rid of weed seeds. And for simplicity of work, remove the dirt in an area that’s going to a meter wider on all sides of the rectangle that you want.

In addition, it is worth thinking about having a base. As manufacturers say, today most greenhouses don’t need that, especially if they (greenhouses) are used only in the spring and summer time. But, seasoned anglers still suggest earning an elementary foundation from a pub. It’s very simple – it’s enough to connect with each other utilizing metal corners and screws four pieces of timber with a cross-section of 10 * 10 cm. The size of such a foundation ought to be equivalent to the foundation of the future greenhouse.

Simple bar base

You might also earn a strip foundation of concrete. He’s more reliable than a bar base, but requires more fiscal and labor costs. By the way, the greenhouse, which will be utilised in winter, without it and do not do with it at all.

Stages of the creation of a strip foundation: a schematic representation

Many producers advise to put in greenhouse structures without building a foundation. For this intention, they equip the frame with special T-shaped legs, so the structure was securely fixed. However, as practice shows, it’s still essential to construct a base: so and the foundation will be more securely fixed and the elements of the basis in contact with the soil, will be saved much longer in its original state.

The principal issue is to deal with the material with specific agents to protect the wood from moisture. The substance is installed on concrete cubes which are dug into the soil. For a six-meter arrangement, they need 10 bits: four to each side and one in the center of the endings.

Before you do the greenhouse , you need to choose the right spot for this. It must be an even site, so the frame was located equally, without distortions. It should be bright and never obscured by buildings or trees.

Categories: greenhouse

Leave a Reply

Your email address will not be published. Required fields are marked *